各位大侠，请翻译一下英文

作者&投稿：娄向（联系方式在网页底部的电邮联系）

请帮忙翻译成英文一下，非常感谢~

GMS Microwave level switch electrical isolation unit consists of three components: a transmitter, receiver and amplifier, transmitter and receiver each other in pairs. In order to obtain good performance need to ensure that the receiver, the transmitter is securely mounted and is a strictly positive right. The transmitter sends to the receiver's ability to detect the microwave having a microwave beam, the microwave beam is transmitted 200 times per second, when the microwave-absorbing material in the same plane as the receiver, the microwave beam will not reach the receiver, the receiver will not detect and therefore measured microwave beam.
When the receiver detects a microwave beam ends, the status change will be triggered when the relay. From the detected state to a series of microwave relay delay time length is set by two separately adjustable potentiometer; effective and a trigger signal for setting the relay, and one for the relay triggered interrupt signal relay The total movement in the signal state change
And to maintain the length of time after you have set. The delay period will cause any change in the status of the delay to start again.
By a receiver sensitivity adjustment potentiometer, after adjustment, and make the reflectivity of the absorption rate between the different materials to be compensated. Similarly, we have to adjust to be detected even if only part of the microwave beam can also change the trigger condition. There are two systems for sensitivity adjustment potentiometer, respectively, for coarse and fine adjustment. When the detected signal is interrupted, the relay status can be
Set energized or de-energized, this mode of the receiver side by binary switch settings.
Amp set up three LED indicators are used to indicate the power supply; valid signal; relay is energized. While the transmitter is only one indicator to indicate power supply.

Fog belongs to compound pollution, pollution sources including coal, automobile exhaust, industrial waste gas, building dust, etc., is one of the biggest pollution emissions coal and gas, coal, mainly used in construction of the coal for heating and air conditioning.Effective control of building energy consumption is to reduce the fog haze, one of the key steps to improve air quality, if you don't pay attention to the building energy efficiency, building energy consumption will happen in the future the problem of excessive, ceaseless overlay, very bad for the environment.
绝对正确

1、Hello lady, welcome you the arrival! If have the valuables please step this check
2、How do you do, ms locker room this way, please。|How do you do, ms export this way, please
4、

生活记录网

各位大侠，请翻译一下英文

相关热门