请英语高手帮帮忙！关于机械的
The above methods are all based on image analysis.
上述方法都是基于图像分析。
There are several traditional, non-image based methods for quantification of internal granule structure.
有几种传统的,非基于图像的量化内部颗粒结构方法。
These methods include pycnometry [27], mercury porosimetry [19,28,29], nitrogen adsorption technique or
这些方法包括pycnometry、汞porosimetry[27](19、28、29]、氮气吸附技术或
BET analysis [28,30] and Inverse Gas Chromatography, IGC, [31].
BET分析[28,30]以及反气相色谱仪,或IGC[31]。
Acquiring the internal granule structure by modern methods, such as image-based techniques, is often costly due to operating and capital costs of equipment such as X-ray micro-tomography (XMT), Magnetic Resonance Imaging (MRI), and Transmission Electron Microscopy(TEM).
用现代的方法获取内部颗粒结构,如影像学技术,往往是昂贵的,由于操作及资金成本，如x射线micro-tomography(XMT)、磁共振成像(MRI)和透射电子显微镜等设备(TEM)。
However, these are more accurate and give more information which cannot otherwise be obtained by the traditional methods.
然而,这些都是更准确的，给出的信息更多, 这些信息也无法用传统方法获得的。
XMT has been used in the field of granulation technology for analysis of the internal structure of granules [19] and tablets [32], external particle shape [33] and characterisation of agglomerate structure for DEM
XMT已被用于颗粒技术领域，分析颗粒(19]和片剂[32]的内在结构外部颗粒形状,[33]和DEM的结块性结构特征
simulations [14].
模拟[14]。
An important challenge of the granulation technology is to produce consistent granule structure and shape which in turn lead to more uniform properties such as strength and dissolution rate.
颗粒技术上的一个重要的挑战是生产出结构和形状一致的颗粒，从而得到更均匀的性质,如强度、溶解率。
This is difficult without introducing a method to quantify the granulestructure.
如果没有一个定量研究颗粒结构的方法，这将是非常困难的。
In this paper we use some structure descriptors such as chord length distribution and phase function to enable quantification of internal structure of granules.
在本文中,我们使用一些结构描述符,如弦长分布和相位函数, 从而量化颗粒的内部结构。
The characterisation of granule strength [34–39] and structure [14] has previously been reported.
各种颗粒的强度[34-39]和结构的特征[14]过去曾有过报告。
However, there is no work on the effect of different operating conditions, such as impeller speed on the internal granule structure.
然而,没有关于不同的操作条件对工作的影响,如叶轮速度对内部颗粒结构的影响的报告。
The objective of this work is to acquire the internal structure of granules by high resolution X-ray microtomography and to analyse it using a software package developed by Stepanek et al. [40].
本文的目的是利用高分辨x射线microtomography获得颗粒的内部结构，并使用一个由Stepanek 等人开发的软件来分析它。【40]。
The granules used in this work were produced at three different impeller speeds in a high shear granulator.
这项工作使用的颗粒是在三种不同速度的叶轮高剪切造粒下产生的。
这个英文很不标准，写这个英文的人，英语也不大好的说。感觉乱乱的。
如下是根据英文字面意思，然后加上一定程度的推测，做出的翻译，供你参考！
备注说明：
1. 硬度和韧度最小为60HRC
2. 所有标这个符号Ф的零件号和等级号，高度为3mm
3. 加工后，所余的碎屑不应超过0.02g
4. 保护组件，以免运输过程中损坏，
5. 部件图上防锈油。防腐蚀。
是否应当充分强调使用去飞边刀片检查错齿的重要性。刀齿上的飞边不是整齐划一的存在0.05毫米的误差就会影响读数。应当非常注意去飞边刀片是否将齿尖磨光。
Q2:Should it be necessary to check the set of hardened blades which had not been previously defashed, any fash may have been burned off and an arbitrary allowance of up to 0.05mm must be made. Fash cannot be accurately removed from set and hardened blade teeth prior to checking.
是否有必要检查之前没有去飞边的硬刀片上的齿。有可能所有的飞边都已被烧掉，多达0.05毫米的额外限制应该被留出。在检查硬刀片之前很难完全将飞边完全从刀齿上移除。
仅供参考，一些较专业的术语不是100%确定。
相关视频
英语高手请进来,帮忙解决一下难题!!!
plane 面（和“飞机”是同一个词）“点线面”: dot-line-plane “线与块面之间组成了对比美”:The beauty formed between lines and planes.或（如果只有一条线和一个块面）：The beauty formed between the line and the plane.[说明一下，这里的“美”应该是“美丽”的含义，不是楼上“美国”的含义。]
求英语高手帮忙翻译下,非常感谢啊!别用翻译器,貌似不准确!在线等_百度知...
二十世纪跨越了三个“电”的时代，即电气时代、电子时代和现已进入的电脑时代。不过，这种电脑，通常是指个人计算机，简称PC机。它由主机、键盘、显示器等组成。还有一类计算机，大多数人却不怎么熟悉。这种计算机就是把智能赋予各种机械的单片机。The 20th century surmounted three ages of “the ...
真诚的跪求各位英语高手帮我解答下这几句英语?
各位英语高手我现在真在学新概念英语44---48这几篇课文现在有几句需要麻烦大家帮忙解答下，大家也知道后面20课也的确很难！！！（1）Aeroplanes have the reputation of being dangerous这句话其实大概就是说飞机危险！我就搞不懂了为什么这样的句子还要用所有格！为什么不直接Aeroplanes have the dangerous...
请高手帮忙翻译机械英语
Machining process and general information:机加工工艺和一般信息：• General Information – Tooling •一般信息－刀具 o Plan to have own engineering group as company expands o 随着公司的发展拥有自己工程集团的计划 o Hwasung is subcontracted to do engineering currently o 目前韩国...
